Analysis of main points of mold sliding mechanism, you can easily demould if you understand it

Mechanisms with lateral parting and core pulling are collectively referred to as sliding mechanism. ...

News2020-03-19



Common failures and troubleshooting of die casting machine!

Once failure of die-casting machine is threatened, operator should pay great attention to it, calmly...

News2020-03-18



Carburizing and nitriding surface treatment process for mold material

Carburizing must use low carbon steel or low carbon alloy steel, which can be divided into three typ...

News2020-03-17



Design experience points for injection mold slider and lifter

Due to special requirements of product, stripping direction of a certain part is inconsistent with m...

News2020-03-16



Design of hot runner mold with multi-direction core pulling

In design process of injection molds, for plastic parts with complex structures, shape, number, and ...

News2020-03-14

Seven-step design method with ejection system

For flat plastic parts with flanges, if a push plate is used to eject mold, ejection mechanism shoul...

News2020-03-13



Is injection molding defective? Let's get it!

Cracking, including filament cracks on the surface of part, microcracking, whitening, cracking, and ...

News2020-03-12



Effect of Tempering Heating Rate on Microstructure and Properties of 3Cr2MnNiMo Steel

With development of petrochemical industry, output of plastic products has increased rapidly. Most p...

News2020-03-11



Solutions for welding marks

When convergence angle of welding marks is less than 135 °, a suture is generated, and when it is ...

News2020-03-10



Mould Design Sharing- Gating System Design (Part 2)

Water inlet method is method by which material enters mold cavity, which is divided into two catego...

News2020-03-09