Optimization of automotive oil pump body die-casting process

In order to meet requirements of high air tightness and high strength of automotive aluminum alloy o...

News2024-04-26



Plastic structure design 6 —part gaps, buckles and stops

This article mainly introduces requirements for parts clearance, buckle positions and stops in desig...

News2024-04-25



Improve performance of die-casting molds and extend service life of die-casting molds

Pressure casting (die casting for short) has characteristics of high production efficiency, short pr...

News2024-04-19



Electric vehicle front cover hot runner mold design

Electric vehicle front hood is shown in Figure 1. Average wall thickness is 2.2mm. Outer wall of pla...

News2024-04-19



Automotive light bracket die-casting process analysis and mold design

Structural characteristics of automobile light bracket were analyzed, die-casting process was design...

News2024-04-18

Common causes and solutions for misjudgment of plastic product quality

As saying goes: "No one is perfect, no gold is pure, no one is a sage, no one can make mistakes!" ...

News2024-04-18



Die casting production case! Research on vacuum die-casting LED lamp radiator castings

Magnesium alloy has characteristics of high specific strength and specific stiffness, good impact re...

News2024-04-17



Contactor base injection mold design

Base is similar to a semi-enclosed box-shaped piece. Coil is installed inside box surrounded by vert...

News2024-04-17



Analysis and solutions for thermal cracking of die-cast ADC12 aluminum alloy mobile phone middle fra

Abstract: Causes of thermal cracking of middle frame of die-cast ADC12 aluminum alloy mobile phones ...

News2024-04-16



It is recommended to refer to eight aspects when talking about injection molding companies reducing

For an injection molding product factory, injection molding process accounts for approximately 60% o...

News2024-04-16