Analysis of examples of imitation failure in die-casting runner design

Abstract: Through analysis of an example of a failed die-casting mold design, key elements that shou...

News2023-12-08



Elastic sleeve molding process analysis and mold design

Structure of elastic sleeve is shown in Figure 1. Material is PC+ABS and shrinkage rate is 0.53% to ...

News2023-12-07



Design of injection mold for nylon elbow joint

Nylon elbow joint has a 2-section elbow structure, material is modified nylon PA6, and shrinkage rat...

News2023-12-06



Injection molding defect form, this is too comprehensive! Please forward to each other

During injection molding process, it is a common phenomenon for products to shrink and dent. Main re...

News2023-12-04



Key Points of Injection Mold Design for Light Guide Column of Medical Therapeutic Instrument

See Figure 1 for light guide column products of medical therapeutic instruments. Maximum dimensions ...

News2023-12-02

How big is role of hot runner, you will know after reading it

Hot runners are already indispensable in injection molding production. For plastic processors, choos...

News2023-11-30



Injection mold exhaust mode

The thinner product, the farther away from gate, opening of exhaust groove becomes particularly imp...

News2023-11-29



Finite element analysis and topology optimization design of fixed mold plate of injection molding ma

With rapid development of China's industrialization process, demand for plastic products has increa...

News2023-11-28



Research on deformation improvement of Gree air conditioner two-color panel in Moldflow simulation a

In recent years, with demand of consumers for personalized appearance, market has increasingly highe...

News2023-11-26



Key points of injection mold design for inner and outer casing of spotlights

Inner and outer casing products of spotlights are shown in Figure 1. Maximum outer dimension of prod...

News2023-11-24