Properties of transparent plastics and common problems that should be paid attention to in injection

Because plastic has advantages of light weight, good toughness, easy molding and low cost, more more...

News2023-07-27



Preventive measures for mold heat treatment deformation and cracking

Abstract: Due to large variety of specifications, complex shape and low surface roughness value of m...

News2023-07-26



Formation and elimination of bubbles in injection molded parts

Air bubbles in product during injection molding are a common problem to be solved.
This article desc...

News2023-07-25



Design of typical automatic thread removal injection mold

In plastic parts, many industrial products and civilian products have internal and external thread d...

News2023-07-24



Design of Injection Mold for Storage Rack Accessories

Length of plastic part is 248mm, width is 203mm, wall thickness is 2mm, and material is ABS. ABS is ...

News2023-07-22

How to make a mold flow analysis report for two-color mold products?

How to make a mold flow analysis report for two-color mold products?...

News2023-07-21



Selection of injection pressure and holding pressure during plastic injection molding

Injection molding cycle, also known as molding cycle, refers to time required to complete an injecti...

News2023-07-20



A complete collection of plastic parts design techniques, this is very useful for plastic molds

Plastic parts are structural designs based on industrial modeling. First, check whether there are si...

News2023-07-19



Design of injection mold for door trim panel of SAIC GM

Figure 1 shows interior trim panel of left front door of a certain model. This door panel adopts an ...

News2023-07-17



Introduction to Plastic Gear Injection Molding

Plastic gears are moving toward larger sizes, more complex geometries, and higher strength, with hig...

News2023-07-15