Do you know design standards of injection molds?

In mold manufacturing, mold exhaust is a very important link. Mold exhaust can represent quality of ...

News2022-10-18



Research on machining chipping of high hardness material edge after quenching

【Abstract】This paper introduces theoretical research, technology development and application of hi...

News2022-10-17



Mould Design of Internal Threaded Plastic Cover

Figure 1 shows plastic cover with internal thread, material is ABS, internal thread specification is...

News2022-10-15



Analysis of key points of injection molding machine management and maintenance

Routine maintenance means that operators of injection molding machine equipment routinely inspect eq...

News2022-10-14



10 things to pay attention to in mold parting process of plastic molds

Note 1 during parting process: shrinkage rate
Shrinkage rate of product determines dimensional accur...

News2022-10-13

You Know You Don't Know - Thermoplastics

There are many varieties of thermoplastics, even same variety has different use and process characte...

News2022-10-12



Design of Large-scale Inverted Laminated Injection Mold

[Abstract] Taking laminated structure design of injection mold for refrigerator heat dissipation cov...

News2022-10-11



Design of large injection mold for playground slide

Playground slide product is shown in Figure 1. Maximum external dimension of product is 1438.89 mm *...

News2022-10-10



An article about engineering thermoplastic elastomer TPES

Well-known engineering thermoplastic elastomer (ETES) has higher strength than rubber (generally 2-6...

News2022-10-09



Teach you correct operation of injection molding machine

Vertical injection molding machine operation
Preparation before starting
Check whether each lubricat...

News2022-10-08