Design of injection mold for end cover of diagnosis and treatment instrument

Product of end cover of diagnostic instrument is shown in Figure 1. Maximum external dimension of pr...

News2022-04-29



Do you know the three types of centralized lubrication systems for injection molding machines?

Guide sleeve of injection molding machine before and after injection, guide sleeve of tie rod of mov...

News2022-04-28



Teach you a few routines to save money in injection molding process

For an injection molding factory, energy consumption of injection molding process accounts for about...

News2022-04-27



Injection mold design for storage box of central armrest box

Car armrest box is a kind of car accessory installed between two seats, which belongs to car interio...

News2022-04-26



Frequently Asked Questions about Hot Runner System

Problem: Cavity is not filled
Reasons: Melting temperature is too low; injection pressure is too sma...

News2022-04-25

What issues should be paid attention to when producing PC polycarbonate products?

PC has excellent performance, high transparency, good impact toughness, creep resistance, and wide o...

News2022-04-24



6 injection molding machine failure repair steps, quickly implement

Both imported and domestic injection molding machines have following characteristics:
Injection mold...

News2022-04-23



Usage of injection speed and precautions for machine adjustment!

Proportional control of injection speed has been widely adopted by injection molding machine manufac...

News2022-04-22



Mould Design of Decorative Parts of Vacuum Cleaner Panel

Small buckle structure is shown in Figure 1. Material is PP, and there is a long inner hole on the s...

News2022-04-21



Using small gates for injection molding has so many advantages!

Gate is a very critical section of material flow channel in gating system. Except for main runner ty...

News2022-04-20