Gas-assisted injection mold design should consider impact on process parameters

Technical characteristics of gas-assisted injection moulding
(1) Design of mold cavity should try to...

News2021-03-24



Warping deformation control of automobile water chamber based on pre-deformation

Plastics are used more and more widely in automobiles, mainly including interior parts, exterior par...

News2021-03-23



Casket quick-change injection mold design

【Abstract】With increasing competition in the market, replacement of plastic products is getting fa...

News2021-03-22



Design of Injection Mold for Coil Frame

Figure 1 shows coil bobbin used for winding, which is molded with high-strength and high-rigidity PC...

News2021-03-20



Structural characteristics and maintenance analysis of hydraulic system and cylinder of injection mo

Equipment that uses plastic molding molds to make thermosetting plastics or thermoplastics into plas...

News2021-03-19

3D design of injection mould for instrument movement bracket

Instrument core bracket is key support part of PCB board of wave soldering equipment control system....

News2021-03-18



Mould replacement instruction book

According to production plan of workshop, make preparations before changing mold.
1. Put on a safety...

News2021-03-16



Design of Complex Core-pulling Injection Mould for Multifunctional Watch Cases

Picture of multi-function watch case is shown in Figure 1. Maximum size of product is 54.82 mm * 36...

News2021-03-15



There are so many principles for selection of parting surfaces, collect them and learn slowly

Selection of parting surface is not only related to molding and demoulding of plastic part, but also...

News2021-03-14



Key points of injection mold design for memory bottom shell + 3D

Product diagram of memory bottom case is shown in Figure 1. Maximum size of product is 170.75 mm * ...

News2021-03-13