News

Design points of injection mold positioning system
Problem of guiding and positioning is repeated staggered actions when injection mold is closed and o...
News1942021-09-16

Design of Injection Mould for 135° Elbow Pipe of Injection Molding Machine
Abstract A 2-cavity two-plate mold was designed for injection molding of plastic parts of 135° elbo...
News1712021-09-15

Heat treatment process of plastic mold parts
Different types of steel are used as plastic molds, their chemical composition and mechanical proper...
News1572021-09-14

Hot runner injection mold design for paper holder
Paper holder is an important part of shell of a certain Japanese brand printer. Product picture is s...
News1552021-09-13

The only way to start injection molding machine!
Irregular start-up process of injection molding machine will cause quality degradation, poor mass pr...
News1452021-09-10

10 classic bolt-proof designs!
Once bolt connection in mechanical equipment is loosened, it will cause bolt to fall off and cause m...
News1382021-09-09

Design of Injection Mould for Shell of Juicer
【Abstract】According to structural characteristics of juicer shell and technical requirements that ...
News1492021-09-08

Quality standards for conventional injection molded parts
This standard mainly stipulates inspection and test methods for various plastic products produced by...
News1562021-09-07

Main points of design of injection mold of scanner cover
Upper cover of scanner is shown in Figure 1. Maximum size of product is 276.43 mm * 57.29mm * 30.6...
News1342021-09-06

Research on Status of Robot Mould Polishing
Mold polishing is one of important processes of mold manufacturing, and it is a bottleneck in mold i...
News5402021-09-03