Talking about mold optimization from perspective of injection molding process 7

Selection and optimization of hot runner molds
Hot runner mold refers to a mold that uses a heating ...

News2024-11-12



Causes and preventive measures of blackening of die castings

Surface of die-casting part shows uneven soot-like, flow mark-like, and spot-like blackening or yell...

News2024-11-11



Share a set of drawer mold design~

1. Customer requirements:
1. This product is a transparent plastic part, clamping line and appearanc...

News2024-11-11



Macro-segregation of Fe and Si elements in cast aluminum alloy die-castings

Aluminum alloy has characteristics of low density, good plasticity, high specific strength, good cor...

News2024-11-08



Do you know what issues should be paid attention to when designing water transport for molds?

As core part of mold, cooling system of injection mold is very important for the entire injection mo...

News2024-11-08

Dynamic Analysis of Packing Force of Die Castings

Abstract: Tightening force of die castings always changes dynamically from cooling of aluminum alloy...

News2024-11-07



Plasticizing parameter setting and optimization method

Injection volume
Injection volume refers to amount of material melt (g) injected into mold by inject...

News2024-11-07



Structural characteristics and formation mechanism of defect zones in die-cast AM60B magnesium alloy

Magnesium alloys are widely used in aerospace, automotive, electronics and other fields due to their...

News2024-11-06



Talking about mold optimization from perspective of injection molding process 6

1. Definition of injection mold molding shrinkage rate
Ratio of size change of injection molded prod...

News2024-11-06



Die-casting process design and optimization of hinge bracket

According to hinge bracket structure, die-casting process design was carried out. Two die-casting pr...

News2024-11-05