The only way to start injection molding machine!

Irregular start-up process of injection molding machine will cause quality degradation, poor mass pr...

News2021-09-10



10 classic bolt-proof designs!

Once bolt connection in mechanical equipment is loosened, it will cause bolt to fall off and cause m...

News2021-09-09



Design of Injection Mould for Shell of Juicer

【Abstract】According to structural characteristics of juicer shell and technical requirements that ...

News2021-09-08



Quality standards for conventional injection molded parts

This standard mainly stipulates inspection and test methods for various plastic products produced by...

News2021-09-07



Main points of design of injection mold of scanner cover

Upper cover of scanner is shown in Figure 1. Maximum size of product is 276.43 mm * 57.29mm * 30.6...

News2021-09-06

Research on Status of Robot Mould Polishing

Mold polishing is one of important processes of mold manufacturing, and it is a bottleneck in mold i...

News2021-09-03



About water tightness test of thermoforming mold

In production process of thermoformed products, mold needs to be continuously cooled by water to ens...

News2021-09-02



Complicated core-pulling injection mould design for shell of printing and fax machine

Shell of printer and fax machine is shown in Figure 1. Maximum size of product is 478.97 mm * 234.4...

News2021-09-01



Introduction of transparent plastic injection molding process

Due to high light transmittance of transparent plastics, strict requirements on the surface quality ...

News2021-08-31



Analysis of four reasons for insufficient filling of injection products

Inaccurate feeding measurement or abnormal feeding control system operation, abnormal injection cycl...

News2021-08-30