Instrument window panel injection mold design

Instrument window panel product is shown in Figure 1. Maximum size of product is 317.93 mm * 167.80...

News2022-02-28



Analysis of advantages and disadvantages of PA6 nylon plastic raw materials

1. High mechanical strength, good toughness, high tensile and compressive strength. Specific tensile...

News2022-02-26



Injection molding machine specification switch machine process

① When machine is running, ensure that hopper is properly installed and raw materials are sufficien...

News2022-02-25



Introduction to polyvinyl butyral resin (PVB) plastics

Because PVB resin has above-mentioned various excellent properties, it is widely used in glued safet...

News2022-02-24



Design of Injection Mould for Sweeping Robot Base

Base product of sweeping robot is shown in Figure 1. Maximum size of product is 403.13 mm * 292.00...

News2022-02-23

Which thermally conductive materials can be added to improve thermal conductivity of plastics!

Thermally conductive plastics refer to a type of plastic products with higher thermal conductivity, ...

News2022-02-22



Design of Injection Mold for Excavator Engine Air Inlet Cover

Working environment of plastic parts of engineering machinery engines is harsh, requirements for use...

News2022-02-21



Introduction and precautions for chemical etching of injection mold

Mold etching (commonly known as mold drying, mold biting, etc.) is a common surface treatment proces...

News2022-02-20



Design of Forming Die for Special Shaped Pipes of Sanitary Ware

Figure 1 shows central water outlet part of bathroom faucet, which is an internal functional part. D...

News2022-02-19



Precautions for release angle and thickness of injection molded parts

There is no certain criterion for size of demolding angle, most of which are determined based on exp...

News2022-02-18