Design of injection mould for left and right armrest insert

Left and right armrests are important parts of a treatment chair. Product diagram is shown in Figure...

News2021-11-22



What problems should be paid attention to when injection molding of polysulfone PSU products

Polysulfone (PSU, also known as PSF) is a high-temperature resistant, high-strength thermoplastic en...

News2021-11-21



Nitrogen gas spring structure/use/selection-data collection

Nitrogen gas spring for molds (referred to as die gas spring or nitrogen gas spring or nitrogen cyli...

News2021-11-20



Information channel monitor body injection mold design

Main product of information channel monitor is shown in Figure 1. Maximum size of product is 168.00 ...

News2021-11-19



Basic parameters and model representation of injection molding machine

Basic parameters of injection molding machine can better reflect size of injection molded product, f...

News2021-11-18

Experimental Research and Parameter Optimization of Slow Wire Cutting SKD11

SKD11 steel has excellent properties such as high strength, high hardness, and high wear resistance,...

News2021-11-17



Selection and installation of injection mold pressure sensor

Pressure sensor can be installed in the nozzle of injection molding machine, hot runner system, cold...

News2021-11-16



Two-color multi-color injection molding technology complete!

Two-color injection molding is to realize a part with two kinds of plastic injection molding.
Two-sh...

News2021-11-15



Why do European molds like to use hot runner technology?

So-called runnerless aggregate mold means that in injection molding, melt in runner always maintains...

News2021-11-14



What is difference between a two-board machine and a three-board machine? Which is better?

With development of material technology, application proportion of plastic parts on automobile bodie...

News2021-11-13