Twenty years of experience with mold engineer, have you got it?

According to statistics, about 2,000 sets of molds are directly and indirectly related to items of ...

News2021-04-30



Reference instructions for setting mold clamping parameters of injection molding machine

1. Start clamping pressure: Initial setting value is 25. When pressure is too small and speed is too...

News2021-04-29



7 factors to be considered in injection molding process cannot be ignored!

Form and calculation of thermoplastic molding shrinkage are as mentioned above. Factors that affect ...

News2021-04-28



Design Essentials of Injection Mould with Needle Valve Type Adiabatic Runner for Channel Cover

Product diagram of channel cover is shown in Figure 1. Maximum size of product is 228.00 mm * 107.3...

News2021-04-27



Must read! Causes and solutions for frequent problems in injection molds

Main element of this shortcoming is poor brightness of gate taper hole and knife mark in circumferen...

News2021-04-26

How to improve working life of plastic machine screw?

Injection screw is operated for a long time under high temperature, high pressure, high mechanical t...

News2021-04-23



Key points of design of injection mold of shielding cover

Product diagram of shield is shown in Figure 1. Maximum size of product is ø85.7 mm * 55.20 mm, av...

News2021-04-22



Design of Injection Mould for Double-Inner Shell with Guide Chute

Molding process of two inner side inclined slider core-pulling of plastic part and analysis of influ...

News2021-04-21



PC polycarbonate resin performance and application overview and Soluble polytetrafluoroethylene (PFA

PC polycarbonate plastic is an almost colorless glassy amorphous polymer with good optical propertie...

News2021-04-20



What is exhaust of cavity? What is sufficient exhaust?

The thinner product, the farther away from gate, opening of exhaust groove becomes particularly impo...

News2021-04-19