News

General Motors applies FLOW-3D: How to reduce entrained air generated when pouring in pressure chamb
In high pressure casting, most of pouring in pressure chamber is done by a robotic arm. During pouri...
News772024-12-12

Moldflow analysis optimization strategy: How to make injection molding results that meet actual situ
Mold design and mold flow analysis are a complementary work system. There are always friends in indu...
News862024-12-12

Die casting defects and their causes, methods to avoid die casting defects
Die casting defects vary. Here are some common die casting defects and their possible causes:
There ...
News782024-12-11

14 undesirable phenomena in nylon injection molding process and corresponding solutions
Nylon plastic products are precise in size, suitable for mass production and molding processing fie...
News732024-12-11

Automobile steering gear die-casting mold design and numerical simulation of molding process
Figure 1 shows structure of casting. Casting is a long tubular shape. Diameter of tube body is φ53....
News722024-12-10

Overview of Machine Adjustment Guide
So-called machine adjustment refers to continuous adjustment of various parameters of injection mold...
News772024-12-10

Technology Frontier|Research on parameters affecting forming of thick-walled parts of die castings
Casting structure and development difficulties of automobile engine main bearing cap bracket are int...
News692024-12-09

Mold ejection method
In order to improve injection molding efficiency and quality of molded products, it is also necessar...
News752024-12-09

Technology Frontier | Research on structural characteristics and formation mechanism of defect zones
Magnesium alloys are widely used in aerospace, automotive, electronics and other fields due to their...
News672024-12-08

Analysis and Improvement of Injection Molding Part Defects - Cold Slug
Cold slug is cold slug generated during melt injection molding process that enters mold cavity, caus...
News852024-12-08