News
How to design die casting mold to help extend life of mold
Correctness of die casting mold design is directly related to output and quality of castings, proces...
News2024-10-08
Experience and skills | Detailed explanation of performance parameters of plastic materials
We mentioned earlier that choice of materials for plastic parts is crucial to product design. So wha...
News2024-10-08
Study on influence of refinement and modification on performance of heat-free aluminum alloy die cas
Al-Zn-Si-Cu alloy was prepared by die-casting forming process, refinement and modification effect of...
News2024-10-07
Super detailed analysis of causes of injection molding defects and improvement measures
Generation of bad problems related to injection molding is caused by many factors: finished product ...
News2024-10-07
Pollution is primary culprit for failure of hydraulic system of injection molding machine!
Quality of hydraulic system of injection molding machine depends not only on rationality of system d...
News2024-10-05
Verification and process optimization of large automobile die-casting mold design by PQ2 diagram
Since advent of pressure casting in the late 1860s, for a long time, design of gate system and its a...
News2024-09-30
Design of injection mold for refrigerator drawer
Structure of refrigerator drawer is complex. As shown in Figure 1, upper part of front side is an ar...
News2024-09-30
Talking about mold optimization from perspective of injection molding process 1
In addition to mastering basic drawing knowledge (such as mechanical drawing, tolerance standards, d...
News2024-09-29
Research on properties of new high-strength die-cast aluminum alloys
Evolution of microstructure and properties of a new high-strength Al-Si-Mg-Mn alloy was studied. Bas...
News2024-09-25
Key points of injection molding technology for TPU mobile phone protective cases.
There are many methods of TPU molding process: including injection molding, blow molding, compressio...
News2024-09-25