How to solve problem of injection part of injection molding machine?

1) Nozzle is blocked by foreign matter. Check whether nozzle is blocked, clean or replace nozzle.
2)...

News2024-07-01



Causes and preventive measures of die casting sticky mold

Mold sticking phenomenon in aluminum alloy die-casting process has always been a difficult problem f...

News2024-06-29



Real god of injection molding machine adjustment skills.

1. The first shot is injected at a low speed, nozzle is moved away from cold material head, and then...

News2024-06-29



Mold optimization design to improve shrinkage cavity of lower cylinder die castings

This article introduces structural characteristics and defect forms of an aluminum alloy lower cylin...

News2024-06-28



Application of polycarbonate in automotive lamps

In automotive lighting system, almost all current car models use polyester materials with good impac...

News2024-06-28

Die-casting design specifications—structural design self-inspection

This series mainly introduces specifications related to die-casting design, including an introductio...

News2024-06-27



Solutions to mold opening problems for plastic products (3)

This article mainly introduces problems that arise during mold opening, mold trial and mass producti...

News2024-06-27



Introduction to injection molding process of headlight BMC reflectors

This is an introduction to injection molding process of headlight reflectors, which is suitable for ...

News2024-06-25



Optimization of aluminum alloy die-casting process for automobile shock tower

Figure 1 is a schematic diagram of a 3D solid model of a shock-absorbing tower. Maximum outline size...

News2024-06-24



It is worth reading carefully, key points and details of design of lifter mechanism

Lifter is one of mechanisms of mold. Before designing, make a systematic analysis of product struc...

News2024-06-24