Design of die casting mold for complex shells

Characteristics of shell die castings were analyzed, casting simulation software ProCAST was used to...

News2024-08-19



Design of automatic demoulding mechanism for external thread

Figure 1 shows a plastic screw in dashboard of a car, which belongs to shaft type plastic part. Scre...

News2024-08-19



What are surface treatment methods for aluminum alloy die castings?

Effects of accelerators, fluoride, Mn2+, Ni2+, Zn2+, PO4 and Fe2+ on phosphating process of aluminum...

News2024-08-17



Application characteristics of new nylon material-PA56!

① Density of PA56 is 1.14g/cm3, which is significantly lower than polyester’s 1.4g/cm3. It can re...

News2024-08-17



Application of a three-plate die-casting mold with double center pouring

Die-casting process plays an important role in current lightweight production of automotive parts. F...

News2024-08-16

Injection molding case analysis (stagnation near gate)

(2) Mold temperature: Moveable and fixed molds are produced by a mold temperature controller at 80...

News2024-08-16



Improvement of die-cast aluminum alloy condensation sheet defects

Due to characteristics of aluminum alloy die-casting process, phenomenon of oxidation and cold mater...

News2024-08-15



Five common data tables necessary for plastics

Rigid polyvinyl chloride has high strength and excellent insulation properties; it has good chemical...

News2024-08-15



Process research on aluminum alloy die-cast battery covers for new energy vehicles

Taking AlSi10MnMg die-cast aluminum alloy battery cover of new energy vehicles as research object, t...

News2024-08-14



What are common methods of mold polishing?

With widespread application of plastic products, such as daily chemical products and beverage packag...

News2024-08-14