News
Improve performance of die-casting molds and extend service life of die-casting molds
Pressure casting (die casting for short) has characteristics of high production efficiency, short pr...
News2024-04-19
Electric vehicle front cover hot runner mold design
Electric vehicle front hood is shown in Figure 1. Average wall thickness is 2.2mm. Outer wall of pla...
News2024-04-19
Automotive light bracket die-casting process analysis and mold design
Structural characteristics of automobile light bracket were analyzed, die-casting process was design...
News2024-04-18
Common causes and solutions for misjudgment of plastic product quality
As saying goes: "No one is perfect, no gold is pure, no one is a sage, no one can make mistakes!" ...
News2024-04-18
Die casting production case! Research on vacuum die-casting LED lamp radiator castings
Magnesium alloy has characteristics of high specific strength and specific stiffness, good impact re...
News2024-04-17
Contactor base injection mold design
Base is similar to a semi-enclosed box-shaped piece. Coil is installed inside box surrounded by vert...
News2024-04-17
Analysis and solutions for thermal cracking of die-cast ADC12 aluminum alloy mobile phone middle fra
Abstract: Causes of thermal cracking of middle frame of die-cast ADC12 aluminum alloy mobile phones ...
News2024-04-16
It is recommended to refer to eight aspects when talking about injection molding companies reducing
For an injection molding product factory, injection molding process accounts for approximately 60% o...
News2024-04-16
Design of an aluminum alloy shell die-casting mold
By analyzing structure and formability of shell parts, we focused on detailed analysis and research ...
News2024-04-15
Plastic structure design 5 —hole, thread, and insert design requirements
It is a common method to open holes in plastic parts to connect them with other parts or to increase...
News2024-04-15