Development of multi-cavity die-casting mold for small brackets based on ProCAST software

There are various small brackets in automobile engine, which support various moving functional parts...

News2024-04-11



Plastic structural design 4 —reinforcement ribs and columns

Reinforcing ribs are an essential feature in design of plastic parts. They are used to increase stre...

News2024-04-11



Design of die-casting mold for new energy vehicle aluminum alloy motor casing based on UG and Anycas

An aluminum alloy motor shell is shown in Figure 1. Material is AlSi12(Fe), shrinkage rate is 0.55%,...

News2024-04-10



Injection molding technology: two-color injection molding application for automotive lights

Two-color injection molding is one of the more popular advanced injection molding methods currently,...

News2024-04-10



Die-casting mold design to adapt to variations in casing structure

For two similar casing die-casting parts, two mold structures and two reasonable push-out mechanisms...

News2024-04-09

Characteristics of transparent raw materials commonly used in plastics and injection molding process

Because plastic is light in weight, has good toughness and is easy to form. Due to its advantages su...

News2024-04-09



Die-casting process analysis and defect improvement of automobile clutch housing

Domestic new-generation CVT gearbox has good fuel economy, power, comfort and low cost, but complexi...

News2024-04-08



[Technical article] How to use CAE to detect product appearance problems

For conventional CAE results, only sutures and encapsulation are directly linked to cosmetic defects...

News2024-04-08



Optimization of die-casting process for magnesium alloy motorcycle crankcase right cover

Magnesium and its alloys have good application prospects in 3C products, transportation, aerospace a...

News2024-04-06



Plastic structure design 3 - wall thickness and draft angle

For previous article, Please read Plastic Structural Design 2 - Mold (Introduction). 
This article...

News2024-04-06