Optimized design of thick-walled light guide mold for car lights

Thick-walled light guide is shown in Figure 1. Maximum outline size is 272 mm * 211 mm * 163 mm, a...

News2024-07-02



Technology Frontier丨Research on Casting Process of Thick-Wall Aluminum Alloy Castings

Theoretical simulations developed based on FEM (Finite Element Methods) are of great significance to...

News2024-07-01



How to solve problem of injection part of injection molding machine?

1) Nozzle is blocked by foreign matter. Check whether nozzle is blocked, clean or replace nozzle.
2)...

News2024-07-01



Causes and preventive measures of die casting sticky mold

Mold sticking phenomenon in aluminum alloy die-casting process has always been a difficult problem f...

News2024-06-29



Real god of injection molding machine adjustment skills.

1. The first shot is injected at a low speed, nozzle is moved away from cold material head, and then...

News2024-06-29

Mold optimization design to improve shrinkage cavity of lower cylinder die castings

This article introduces structural characteristics and defect forms of an aluminum alloy lower cylin...

News2024-06-28



Application of polycarbonate in automotive lamps

In automotive lighting system, almost all current car models use polyester materials with good impac...

News2024-06-28



Die-casting design specifications—structural design self-inspection

This series mainly introduces specifications related to die-casting design, including an introductio...

News2024-06-27



Solutions to mold opening problems for plastic products (3)

This article mainly introduces problems that arise during mold opening, mold trial and mass producti...

News2024-06-27



Introduction to injection molding process of headlight BMC reflectors

This is an introduction to injection molding process of headlight reflectors, which is suitable for ...

News2024-06-25