14 Frequently Asked Questions in Mold Manufacturing Field [Part 2]

If a square shoulder milling cutter is used for rough milling of cavity, a large amount of step-shap...

News2024-07-10



Quality optimization of low-pressure casting electric vehicle subframe

Aiming at defects such as isolated liquid phase, hot joints and porosity in low-pressure casting cau...

News2024-07-08



Key points of injection mold design for car interior panel

Car interior panel product diagram is shown in Figure 1. Maximum outer dimension of product is 301.4...

News2024-07-08



A brief discussion on how to make lifter fast and good

Foreword:
When designing plastic molds, when we take over a product for a new project, we first simp...

News2024-07-06



Engine chain cover die-casting mold design

With rapid development of automobile industry, there are more and more aluminum alloy die-casting pa...

News2024-07-05

14 Frequently Asked Questions in Mold Manufacturing Field [Part 1]

Forming method - Choose from two basic material types.
A) Hot work tool steel, which can withstand r...

News2024-07-05



Die-casting design specifications - treatment of defects in die-casting parts

This series mainly introduces specifications related to die-casting design, including an introductio...

News2024-07-04



Design of injection mold for B-pillar exterior trim panel of car front door based on CAX

【Abstract】Introduces practical structure of injection mold for B-pillar exterior trim panel of aut...

News2024-07-04



12 kinds of bolt loosening methods, how many do you know?

As a tool commonly used in fixtures, bolts are widely used, but long-term use will also bring many p...

News2024-07-03



Analysis on processing problems of die-cast aluminum alloy materials

Abstract: Die-cast aluminum alloy is one of the more common metal parts materials nowadays. However,...

News2024-07-02