Research on mechanical properties of aluminum alloy die-casting parts after heat treatment

Aluminum alloys are widely used in industry due to their good formability, processability, weldabili...

News2024-05-28



Twenty-one properties of plastics, this time I sorted them all out

1. ABS plastic
English name: Acrylonitrile Butadiene Styrene
Specific gravity: 1.05 g/cm3 Molding sh...

News2024-05-28



Die Casting Design Specifications—Basic Introduction

This series mainly introduces specifications related to die-casting design, including an introductio...

News2024-05-27



Meter end cover forming process analysis and mold design

End cover of electric meter is shown in Figure 1. It has a thin-walled structure as a whole, with de...

News2024-05-27



Effect of surface quality of injection chamber of die-casting machine on shrinkage and porosity defe

With rapid development of automobile industry, automobiles are gradually developing towards high per...

News2024-05-25

Plastic parts｜Basic properties of engineering plastics

Engineering plastics can be used as engineering materials and plastics that replace metal in manufac...

News2024-05-25



Application and development of aluminum and magnesium alloy die castings in automotive industry

With innovation and development of new alloy materials, die-casting technology with high product qua...

News2024-05-24



14 retracted structural designs, structure is very difficult, boss will increase salary if it is sol

Today I saw an injection molded product that is an inner cover with a diameter of 150MM. Its interna...

News2024-05-24



Analysis and Countermeasures on Main Defects of DCT Transmission Housing

Since DCT transmission housing of a certain automobile manufacturer was developed and put into produ...

News2024-05-23



Design of injection mold for front and rear vertical plates of LCD base

Product diagram of front and rear vertical plates of LCD base is shown in Figure 1. Maximum external...

News2024-05-23