Key points of injection mold design for battery pack cover

Battery pack cover product is shown in Figure 1. Maximum dimensions of product are 365.0 mm * 230.0...

News2024-07-12



Analysis of service cracking failure of aluminum alloy die-casting mold parts

Cracking characteristics of mold parts are shown in the oval in Figure 2. An aluminum alloy die-cast...

News2024-07-11



Design reference for several special screws for plastics

1. PC material (polycarbonate)
Features:
① Non-crystalline plastic, no obvious melting point, glass...

News2024-07-11



How to calculate die casting mold cost?

Want to determine components of mold cost:
1. Split cost components;
2. Determine calculation formul...

News2024-07-10



14 Frequently Asked Questions in Mold Manufacturing Field [Part 2]

If a square shoulder milling cutter is used for rough milling of cavity, a large amount of step-shap...

News2024-07-10

Quality optimization of low-pressure casting electric vehicle subframe

Aiming at defects such as isolated liquid phase, hot joints and porosity in low-pressure casting cau...

News2024-07-08



Key points of injection mold design for car interior panel

Car interior panel product diagram is shown in Figure 1. Maximum outer dimension of product is 301.4...

News2024-07-08



A brief discussion on how to make lifter fast and good

Foreword:
When designing plastic molds, when we take over a product for a new project, we first simp...

News2024-07-06



Engine chain cover die-casting mold design

With rapid development of automobile industry, there are more and more aluminum alloy die-casting pa...

News2024-07-05



14 Frequently Asked Questions in Mold Manufacturing Field [Part 1]

Forming method - Choose from two basic material types.
A) Hot work tool steel, which can withstand r...

News2024-07-05