Plastic mold "two-color mold" hot runner to three-plate mold design points and precautions

As picture shows:
First color material: PA66+20%PTFE
Second color material: PA+60%GF
Above two mater...

News2022-08-30



Stop trying to control injection molding process with machine settings!

What do you do after you have established a stable injection molding process? You might document par...

News2022-08-29



Influencing factors of plastic shrinkage

Shrinkage rate of plastic refers to percentage of difference between size of plastic part at molding...

News2022-08-28



Process flow and skills of mold polishing

Polishing is a very important process in mold making process, and it is also final work. With wide a...

News2022-08-27



Analysis of Failure Causes of Injection Molding Hot Runner System

Compared with ordinary runner molds, hot runner molds have significant advantages such as time savin...

News2022-08-26

How to optimize injection molding process and improve electroplating performance of PC/ABS

Electroplated PC/ABS parts are widely used in automobiles, home appliances and IT industries due to ...

News2022-08-25



Injection molding engineer must! Super practical calculation formulas of common injection molding pr

1. Clamping force F(TON) formula:
F=Am*Pv/1000
F: Clamping force: TON Am: Cavity projected area: CM2...

News2022-08-24



You can't miss experience of injection molding process and parameter adjustment, turn it up! !

After epidemic, where will injection molding industry go?
First. Injection molding process can be si...

News2022-08-23



Force Analysis of lifter of Injection Mould

【Abstract】By simplifying force condition of lifter structure of injection mold, theoretical analy...

News2022-08-22



Design of grid injection mold based on Moldflow simulation analysis

Figure 1 shows two similar middle cover grilles of a fan disk, maximum external dimensions are 200.3...

News2022-08-20